SUSPENSION CONTROL ECU INSTALLATION

PROCEDURE

1. INSTALL ABSORBER CONTROL ECU

   
   

   1. Install the absorber control ECU with the bolt and nut.

      Torque:

      Bolt

      13.5 N*m  { 138 kgf*cm, 10 ft.*lbf }

      Nut

      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

      Note

      
      

      • Avoid any impact to the absorber control ECU.

      • Do not drop the absorber control ECU. If it is dropped, replace it with a new one.

   2. Connect the 3 connectors.

   3. Engage the 2 clamps and install the connector holder to the body.

   4. Return the floor carpet to its original position.

2. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

   Click here

3. INSTALL FRONT DOOR OPENING TRIM COVER RH

   Tech Tips

   Use the same procedure for the RH side and LH side.

   Click here

4. INSTALL FRONT DOOR SCUFF PLATE RH

   Tech Tips

   Use the same procedure for the RH side and LH side.

   Click here

5. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   
   

   • When disconnecting the cable from the negative (-) auxiliary battery terminal, some systems need to be initialized after the cable is reconnected.

     Click here

   • After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode.

     Click here

6. INSTALL BATTERY SERVICE HOLE COVER LH

   Click here