SUSPENSION CONTROL ECU REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable from the negative (-) auxiliary battery terminal, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure for the RH side and LH side.

    Click here

  5. REMOVE FRONT DOOR OPENING TRIM COVER RH

    Tech Tips

    Use the same procedure for the RH side and LH side.

    Click here

  6. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

    Click here

  7. REMOVE ABSORBER CONTROL ECU


    1. Fold back the floor carpet.

    2. A0021OL

      Disengage the 2 clamps and separate the connector holder from the body.

      Note

      Do not apply excessive force to the wire harnesses.

    3. A0021GT

      Disconnect the 3 connectors.

    4. Remove the bolt, nut and absorber control ECU.

      Note


      • Avoid any impact to the absorber control ECU.

      • Do not drop the absorber control ECU. If it is dropped, replace it with a new one.