REAR AXLE HUB ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

Note

When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1341, C1342, C1343 and/or C1344 may be stored. As there is no malfunction, clear the DTCs.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

  2. REMOVE ABS MOTOR RELAY

    for LHD: Click here

    for RHD: Click here

  3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  4. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

    Click here

  5. REMOVE REAR DISC

    Click here

  6. INSPECT REAR AXLE HUB BEARING LOOSENESS


    1. A011MSQ

      Using a dial indicator, check for looseness near the center of the rear axle hub.

      Maximum Looseness
      0.05 mm (0.00196 in.)

      Note


      • Ensure that the dial indicator is set perpendicular to the measurement surface.

      • Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.

      If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.

  7. INSPECT REAR AXLE HUB RUNOUT


    1. A011Q32

      Using a dial indicator, check for runout on the surface of the rear axle hub outside the rear axle hub bolts.

      Maximum Runout
      0.05 mm (0.00196 in.)

      Note


      • Ensure that the dial indicator is set perpendicular to the measurement surface.

      • Make sure to install the tip of the dial indicator towards the outside of the rear axle hub bolts.

      • Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.

      If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.

  8. INSTALL REAR DISC

    Click here

  9. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG

    Click here

  10. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  11. ADJUST PARKING BRAKE

    Click here

  12. INSTALL ABS MOTOR RELAY


    1. With the power switch off, install the 2 ABS motor relays (ABS motor No. 1 relay and ABS motor No. 2 relay).

    2. Clear the DTCs.

      Click here

  13. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }