STEERING KNUCKLE INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   INSTALL STEERING KNUCKLE

   
   

   1. Install the steering knuckle to the front upper suspension arm assembly with the nut.

      87 N*m

      887 kgf*cm

      64 ft.*lbf

      Note:

      Prevent oil from adhering to the threaded and tapered parts.

   2. Install a new clip.

      Note:

      Further tighten the nut up to 60° if the holes for the clip are not aligned.

2. Click here

   INSTALL FRONT LOWER BALL JOINT ASSEMBLY

   
   

   1. Install the front lower ball joint assembly to the steering knuckle with the 2 bolts.

      120 N*m

      1224 kgf*cm

      89 ft.*lbf

3. Click here

   INSTALL FRONT AXLE HUB SUB-ASSEMBLY

   Click here

4. Click here

   INSPECT FRONT AXLE HUB BEARING LOOSENESS

   Click here

5. Click here

   INSPECT FRONT AXLE HUB RUNOUT

   Click here

6. Click here

   INSTALL FRONT DISC

   Click here

7. Click here

   INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

   Click here

8. Click here

   CONNECT SKID CONTROL SENSOR WIRE

   Click here

9. Click here

   INSTALL FRONT WHEEL

   103 N*m

   1050 kgf*cm

   76 ft.*lbf

10. Click here

    INSTALL ABS MOTOR RELAY

    
    

    1. With the power switch off, install the 2 ABS motor relays (ABS motor No. 1 relay and ABS motor No. 2 relay).

    2. Clear the DTCs.

       Click here

11. Click here

    INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

    Click here

12. Click here

    CHECK FOR SPEED SENSOR SIGNAL

    Click here