PROPELLER SHAFT ASSEMBLY REASSEMBLY

CAUTION / NOTICE / HINT

Note


  • When using a vise, place aluminum plates between the part and vise.

  • When using a vise, do not overtighten it.

PROCEDURE


  1. INSTALL NO. 1 CENTER SUPPORT BEARING ASSEMBLY


    1. A011OHTC02
      *a Turn
      *b Hold

      Using SST, install a new No. 1 propeller shaft dust deflector.

      SST
      09316-60011   ( 09316-00011 )
      09506-35010
      09950-40011   ( 09951-04020, 09952-04010, 09953-04030, 09954-04030, 09955-04021, 09958-04011 )

      Note

      Be careful not to damage the No. 1 propeller shaft dust deflector.

    2. A011OBGC02
      *a Turn
      *b Hold

      Using SST, install the No. 1 center support bearing assembly.

      SST
      09330-50010
      09950-00020
      09950-40011   ( 09951-04020, 09953-04030 )
      09950-50013   ( 09952-05010, 09954-05080, 09955-05040 )

      Note

      Be sure to install the bearing in the correct direction.

    3. A011PV6C01
      *a Turn
      *b Hold

      Using SST, insert a new No. 2 propeller shaft dust deflector until it almost touches the rubber of the No. 1 center support bearing assembly.

      SST
      09330-50010
      09950-00020
      09950-40011   ( 09951-04020, 09953-04030 )
      09950-50013   ( 09952-05010, 09954-05080, 09955-05040 )

      Note

      Be careful not to damage the No. 2 propeller shaft dust deflector.

    4. A011LXK

      Using a snap ring expander, install a new No. 2 propeller shaft dust deflector snap ring.

  2. INSTALL PROPELLER INTERMEDIATE SHAFT ASSEMBLY


    1. A011O53C03
      *a Protective Tape

      Install the sliding shaft boot.

      Note

      Assemble the propeller intermediate shaft assembly after wrapping protective tape around the splines so that they will not damage the boot.

    2. Apply grease to the splines.

      Grease
      Molybdenum disulphide lithium base NLGI No. 2

    3. Install the adjusting nut to the propeller intermediate shaft assembly.

    4. A011MELC02
      *1 Propeller Intermediate Shaft Assembly
      *2 Propeller Shaft Assembly
      *a Matchmark

      Align the matchmarks and install the propeller intermediate shaft assembly to the propeller shaft assembly.

      Note

      The direction of the propeller intermediate shaft assembly companion flange and the propeller shaft assembly companion flange should differ by 180°.

    5. Cover the adjusting nut with the sliding shaft boot.

    6. Temporarily tighten the adjusting nut by hand.