SHIFT LEVER INSPECTION

PROCEDURE


  1. INSPECT TRANSMISSION FLOOR SHIFT ASSEMBLY

    Tech Tips

    If the results of the following inspections are as specified but a malfunction has occurred, replace the transmission floor shift assembly.


    1. Disconnect the shift lock control ECU connector.

    2. A01MSU4C04
      *a

      Front view of wire harness connector

      (to Shift Lock Control ECU)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      5 (IG) - Body ground Power switch on (IG) 11 to 14 V
      Power switch off Below 1 V
      4 (STP) - Body ground Brake pedal depressed 11 to 14 V
      Brake pedal released Below 1 V

      If the result is not as specified, repair or replace the shift lock control ECU wire harness.

    3. A01MSU4C05
      *a

      Front view of wire harness connector

      (to Shift Lock Control ECU)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (E) - Body ground Always Below 1 Ω

      If the result is not as specified, repair or replace the shift lock control ECU wire harness.

  2. INSPECT TRANSMISSION CONTROL SWITCH (for LHD)


    1. Disconnect the transmission control switch connector.

    2. A01MTC5C23
      *a

      Component without harness connected

      (Transmission Control Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      4 (IG) - 5 (S) Shift lever in S, "+" or "-" Below 1 Ω
      Shift lever not in S, "+" or "-" 10 kΩ or higher
      3 (SFTU) - 2 (E) Shift lever held in "+" Below 1 Ω
      Shift lever not held in "+" 10 kΩ or higher
      1 (SFTD) - 2 (E) Shift lever held in "-" Below 1 Ω
      Shift lever not held in "-" 10 kΩ or higher

      If the result is not as specified, replace the transmission floor shift assembly.

  3. INSPECT TRANSMISSION CONTROL SWITCH (for RHD)


    1. Disconnect the transmission control switch connector.

    2. A01MTC5C15
      *a

      Component without harness connected

      (Transmission Control Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      4 (IG) - 5 (S) Shift lever in S, "+" or "-" Below 1 Ω
      Shift lever not in S, "+" or "-" 10 kΩ or higher
      1 (SFTU) - 2 (E) Shift lever held in "+" Below 1 Ω
      Shift lever not held in "+" 10 kΩ or higher
      3 (SFTD) - 2 (E) Shift lever held in "-" Below 1 Ω
      Shift lever not held in "-" 10 kΩ or higher

      If the result is not as specified, replace the transmission floor shift assembly.