SHIFT LEVER ADJUSTMENT

PROCEDURE


  1. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

    Click here

  2. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR

    Click here

  3. ADJUST SHIFT LEVER POSITION


    1. Move the shift lever to N.

    2. A0020HLC01
      *a Lever

      Remove the nut and separate the floor shift gear shifting rod sub-assembly from the lever of the transmission floor shift assembly.

    3. A0022HLN01

      Turn the transmission control shaft lever counterclockwise until it stops, then turn it clockwise 2 notches.

    4. A00227KC02
      *a Lever
      B003YHT Pushing the lever rearward

      Temporarily install the floor shift gear shifting rod sub-assembly to the lever of the transmission floor shift assembly with the nut.

    5. Tighten the nut while lightly pushing the lever of the transmission floor shift assembly rearward.

      Torque:
      12.8 N*m  { 131 kgf*cm, 9 ft.*lbf }

      Note

      Do not push the lever of the transmission floor shift assembly too hard.

  4. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR

    Click here

  5. INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

    Click here

  6. INSPECT SHIFT LEVER POSITION

    Click here

  7. INSPECT FOR EXHAUST GAS LEAK

    Click here