REAR DRIVE SHAFT ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL REAR DRIVE SHAFT ASSEMBLY LH


    1. Install a new shaft snap ring.

      Note

      Face the end gap of the shaft snap ring downward.

    2. Coat the splines of the rear drive inboard joint assembly with differential gear oil LT.

    3. A0020AC

      Align the inboard joint splines, and using a brass bar and a hammer, install the rear drive shaft assembly LH.

      Note


      • Face the end gap of the shaft snap ring downward.

      • Do not damage the rear differential side gear shaft oil seal.

      • Do not damage the inboard joint boot.

      • Install the rear drive shaft assembly LH while keeping it level.

      Tech Tips

      Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.

  2. INSTALL REAR DRIVE SHAFT ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  3. INSTALL REAR AXLE ASSEMBLY LH

    Click here

  4. INSTALL REAR AXLE ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  5. INSTALL REAR SUSPENSION MEMBER BRACE LH


    1. Install the rear suspension member brace LH with the 2 bolts.

      Torque:
      56 N*m  { 571 kgf*cm, 41 ft.*lbf }

  6. INSTALL REAR SUSPENSION MEMBER BRACE RH

    Tech Tips

    Use the same procedure as for the LH side.