REAR DRIVE SHAFT ASSEMBLY INSPECTION

CAUTION / NOTICE / HINT

Note


  • When using a vise, place aluminum plates between the part and vise.

  • When using a vise, do not overtighten it.

PROCEDURE


  1. INSPECT REAR DRIVE SHAFT ASSEMBLY

    Note

    Keep the drive shaft assembly level during inspection.


    1. A011N12

      Check that there is no excessive play in the radial direction of the outboard joint.

    2. Check that the inboard joint slides smoothly in the thrust direction.

    3. Check that there is no excessive play in the radial direction of the inboard joint.

    4. Check the boots for damage.

    5. A011PD7N01

      Check that the 2 joint boots are not stretched or contracted when the rear drive shaft is at the standard length.

      Dimension (A)
      LH Side 682.9 mm (2.24 ft.)
      RH Side 728.9 mm (2.39 ft.)