PROPELLER SHAFT ASSEMBLY DISASSEMBLY

PROCEDURE


  1. REMOVE PROPELLER INTERMEDIATE SHAFT ASSEMBLY


    1. A011PF7C02
      *a Matchmark

      Put matchmarks on the propeller intermediate shaft assembly and propeller shaft assembly.

    2. Disconnect the propeller intermediate shaft assembly and propeller shaft assembly.

      Note

      Be careful not to damage the splines.

    3. Remove the adjusting nut from the propeller intermediate shaft assembly.

    4. If the sliding shaft boot is to be reused, wrap protective tape around the splines, so it will not be damaged.

    5. A011MPNC04
      *a Protective Tape

      Remove the sliding shaft boot from the propeller shaft assembly.

  2. REMOVE NO. 1 CENTER SUPPORT BEARING ASSEMBLY


    1. A011MKM

      Using a snap ring expander, remove the No. 2 propeller shaft dust deflector snap ring.

    2. A011Q1FN01

      Using SST and a press, remove the No. 1 center support bearing assembly and No. 2 propeller shaft dust deflector.

      SST
      09950-00020
    3. A011QIJN02

      Using SST and a press, remove the No. 1 propeller shaft dust deflector.

      SST
      09950-00020