DYNAMIC RADAR CRUISE CONTROL SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • Use the following procedure to troubleshoot the dynamic radar cruise control system.

  • *: Use the GTS.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. INSPECT AUXILIARY BATTERY VOLTAGE


    1. Measure the auxiliary battery voltage with the power switch off.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the auxiliary battery before proceeding to the next step.

      Result
      Proceed to
      NEXT

    NEXT

  3. INSPECT MILLIMETER WAVE RADAR SENSOR ASSEMBLY (BEAM AXIS MISALIGNMENT READING)*


    1. Adjust the reflector height.

      Click here

    2. Place the reflector.

      Click here

    3. Connect the GTS to the DLC3.

    4. Turn the power switch on (IG).

    5. Turn the GTS on.

    6. Turn the cruise control switch (ON/OFF button) on.

    7. Enter the following menus: Powertrain / Radar Cruise / Utility / Beam Axis Misalignment Reading.

    8. Check the amount of misalignment and make a note.


      Powertrain > Radar Cruise > Utility
      Tester Display
      Beam Axis Misalignment Reading
      Result
      Proceed to
      NEXT

    NEXT

  4. CHECK CAN COMMUNICATION SYSTEM*


    1. Use the GTS to check if the CAN communication system is functioning normally.

      Click here

      Result
      Result Proceed to
      CAN communication system DTCs are not output A
      CAN communication system DTCs are output B

    B

    GO TO CAN COMMUNICATION SYSTEM Click here

    A

  5. CHECK FOR DTCs (RADAR CRUISE)*


    1. Check for DTCs and note any codes that are output.

      Click here


      Powertrain > Radar Cruise > Trouble Codes

    2. Clear the DTCs.

      Click here


      Powertrain > Radar Cruise > Clear DTCs

    3. Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.

      Click here


      Powertrain > Radar Cruise > Trouble Codes
      Result
      Result Proceed to
      DTCs are not output A
      DTCs are output B

    B

    GO TO DTC CHART Click here

    A

  6. PROBLEM SYMPTOMS TABLE

    Tech Tips

    Refer to Problem Symptoms Table.

    Click here

    Result
    Result Proceed to
    Fault is not listed in Problem Symptoms Table A
    Fault is listed in Problem Symptoms Table B

    B

    GO TO STEP 8 Click here

    A

  7. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Terminals of ECU

      Click here

    2. Data List / Active Test

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  8. ADJUST, REPAIR OR REPLACE

    Note

    When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

    Click here

    Result
    Proceed to
    NEXT

    NEXT

  9. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END