FUEL PRESSURE REGULATOR REMOVAL

CAUTION / NOTICE / HINT

Note

• Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembly of the fuel suction tube with pump and gauge assembly to be impossible as the tube is pressed into the fuel suction plate sub-assembly.

• When replacing the fuel filter, replace it together with the fuel suction plate sub-assembly.

*a

Tube

PROCEDURE

1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

   Click here

2. REMOVE FUEL SENDER GAUGE ASSEMBLY

   Click here

3. REMOVE FUEL FILTER

   Click here

4. REMOVE JET PUMP

   Click here

5. REMOVE FUEL PUMP HARNESS

   Click here

6. REMOVE NO. 1 FUEL SUCTION SUPPORT

   Click here

7. REMOVE FUEL PUMP WITH FILTER ASSEMBLY

   Click here

8. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

   
   

   1. 

      Using a screwdriver with its tip wrapped with protective tape, remove the fuel pressure regulator assembly.

      Note

      Slowly pull out the fuel pressure regulator assembly because the O-ring is firmly installed between the fuel pressure regulator assembly and the fuel filter.

   2. 

      *1

      O-ring

      Remove the 2 O-rings from the fuel pressure regulator assembly.