SERVICE PLUG GRIP REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    The hybrid system has high-voltage circuits. Accidents, such as electric shock, or electric leaks may result if the hybrid system is not operated in a correct manner. Make sure to follow the correct procedure.

    Click here

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  5. REMOVE LUGGAGE COMPARTMENT TRIM BOX

    Click here

  6. REMOVE NO. 5 HYBRID BATTERY SHIELD PANEL


    1. A0021CI

      Remove the 3 nuts and No. 5 hybrid battery shield panel from the HV battery.

  7. REMOVE SERVICE PLUG GRIP

    CAUTION:


    • Wear insulated gloves.

    • Remove the service plug grip to interrupt the high voltage circuit at the time of inspection or repair.

    • Keep the removed service plug grip in your pocket to prevent other technicians from accidentally reconnecting it while you are servicing the vehicle.

    • All the high voltage wiring connectors are orange.


    1. Wear insulated gloves and remove the service plug grip after sliding the lever of the service plug grip as shown in the illustration.

      B003YND

      CAUTION:


      • Keep the removed service plug grip in your pocket to prevent other technicians from accidentally reconnecting it while you are servicing the vehicle.

      • After removing the service plug grip, do not touch the high voltage connectors or terminals for 10 minutes.

      Tech Tips

      Waiting for at least 10 minutes is required to discharge the high voltage capacitor inside the inverter with converter assembly.