Click here

HYBRID CONTROL SYSTEM, Diagnostic DTC:P06A4-209, P06A5-210

Click here
Click here
DTC Code DTC Name
P06A4-209 Sensor Reference Voltage "D" Circuit Low
P06A5-210 Sensor Reference Voltage "D" Circuit High
Click here

DESCRIPTION

The power management ECU monitors the 5V power source (VC) voltage for sensors. If an abnormality is detected, it stores a DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate
P06A4-209 Sensor Reference Voltage "D" Circuit Low

VC power-supply voltage is lower than 4.2 V

(1 trip detection logic)

 Power management control ECU Does not come on

Master Warning Light:

Comes on
P06A5-210 Sensor Reference Voltage "D" Circuit High

VC power-supply voltage is higher than 5.8 V

(1 trip detection logic)

 Power management control ECU Does not come on

Master Warning Light:

Comes on
Click here

CAUTION / NOTICE / HINT

Tip:

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.


  1. Turn the power switch on (IG) and wait for 15 seconds or more.

Click here

PROCEDURE


  1. Click here

    CHECK DTC OUTPUT (HYBRID CONTROL)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

    4. Check for DTCs.


      1. Powertrain > Hybrid Control > Trouble Codes


      Result
      Result Proceed to
      P06A4-209 or P06A5-210 only is output, or DTCs except the ones in the table below are also output. A
      Any of the following DTCs are also output. B
      Relevant DTC
      P0516-769 Battery Temperature Sensor Circuit Low
      P0517-770 Battery Temperature Sensor Circuit High
      P0A2C-247 Drive Motor "A" Temperature Sensor Circuit Low
      P0A2D-249 Drive Motor "A" Temperature Sensor Circuit High
      P0A38-257 Generator Temperature Sensor Circuit Low
      P0A39-259 Generator Temperature Sensor Circuit High
      P2120-152 Throttle / Pedal Position Sensor / Switch "D" Circuit
      P2122-104 Throttle / Pedal Position Sensor / Switch "D" Circuit Low Input
      P2123-105 Throttle / Pedal Position Sensor / Switch "D" Circuit High Input
      P2125-153 Throttle / Pedal Position Sensor / Switch "E" Circuit
      P2127-107 Throttle / Pedal Position Sensor / Switch "E" Circuit Low Input
      P2128-108 Throttle / Pedal Position Sensor / Switch "E" Circuit High Input
      Tip:

      P06A4-209 or P06A5-210 may be stored due to a malfunction which also causes DTCs in the preceding table to be stored. In this case, first troubleshoot the output DTCs in the preceding table. Then, perform a test to attempt to reproduce the problems, and check that no DTCs are output.

    5. Turn the power switch off.


    • A

      REPLACE POWER MANAGEMENT CONTROL ECUClick here

    • B

      GO TO DTC CHART (HYBRID CONTROL SYSTEM)Click here