AIR FUEL RATIO SENSOR INSTALLATION

PROCEDURE


  1. INSTALL AIR FUEL RATIO SENSOR

    Tech Tips

    Perform "Inspection After Repair" after replacing an air fuel ratio sensor.



    1. A0022IJC01
      *a

      Length of SST

      30 mm (1.18 in.)
      *b

      Length of Torque Wrench

      260 mm (10.2 in.)

      Using SST, install the air fuel ratio sensor to the exhaust manifold converter sub-assembly.

      SST
      09224-00010
      Torque:
      without SST [Torque (N*m(kgf*cm, ft.*lbf))]
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST [Reading of Torque wrench (N*m(kgf*cm, ft.*lbf))]
      39 N*m  { 398 kgf*cm, 29 ft.*lbf }

      Note

      If an air fuel ratio sensor has been struck or dropped, replace it.

      Tech Tips


      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 260 mm (10.2 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

        Click here

    2. A002094C01
      *1 Wire Harness Clamp Bracket
      *a Air Hole

      Install the wire harness clamp bracket to the air fuel ratio sensor and connect the clamp.

      Tech Tips

      Wire harness clamp bracket does not fill the air hole in.

    3. Connect the air fuel ratio sensor connector.

  2. CONNECT GENERATOR CABLE (for RHD)

    Click here

  3. CONNECT MOTOR CABLE (for RHD)

    Click here

  4. INSTALL INVERTER TERMINAL COVER (for RHD)

    Click here

  5. INSTALL INVERTER MOTOR CABLE BRACKET ASSEMBLY (for RHD)

    Click here

  6. INSTALL SERVICE PLUG GRIP (for RHD)

    Click here

  7. INSPECT FOR EXHAUST GAS LEAK

    Click here

  8. PERFORM INITIALIZATION


    1. Perform "Inspection After Repair" after replacing an air fuel ratio sensor.