KNOCK SENSOR INSTALLATION

PROCEDURE


  1. INSTALL KNOCK CONTROL SENSOR

    Tech Tips

    Perform "Inspection After Repair" after replacing the knock control sensor.



    1. A011NKLC02
      *a Top
      *b Engine Front

      Install the knock control sensor to the cylinder block sub-assembly with the bolt as shown in the illustration.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

      Note


      • Make sure that the knock control sensor is in the correct position.

      • If a knock control sensor has been struck or dropped, replace it.

    2. Connect the knock control sensor connector.

  2. INSTALL INTAKE MANIFOLD

    Click here

  3. PERFORM INITIALIZATION


    1. Perform "Inspection After Repair" after replacing the knock control sensor.