ECM REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

    Click here

  2. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  4. REMOVE ECM


    1. A002111

      Disconnect the wire harness clamp.

    2. Push the locks on the 2 levers, then raise the 2 levers, and disconnect the 2 ECM connectors.

      Note

      After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.

    3. A0022Z8

      Disconnect the 3 wire harness clamps.

    4. A00236G

      Remove the 2 nuts and ECM.

      Note

      If the ECM has been struck or dropped, replace it.

  5. REMOVE NO. 1 ECM BRACKET


    1. A0022DT

      Remove the 2 bolts and No. 1 ECM bracket from the engine room ECU box.

  6. REMOVE NO. 2 ECM BRACKET


    1. A00235C

      Remove the 2 bolts and No. 2 ECM bracket from the engine room ECU cover.

  7. REMOVE ENGINE ROOM ECU COVER


    1. A0021NG

      Disengage the 3 claws to remove the engine room ECU cover from the engine room ECU box.

  8. REMOVE ENGINE ROOM ECU BOX


    1. Remove the engine room ECU box from the ECM.