POWER WINDOW REGULATOR MOTOR(for Rear Door) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY

   Note

   The regulator arm must be below the intermediate position when installing the rear power window regulator motor assembly.

   
   

   1. 

      Using a T25 "TORX" socket wrench, install the rear power window regulator motor assembly with the 3 screws.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      When replacing a rear power window regulator motor assembly, a new rear power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

2. INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY

   Click here

3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

   Click here

4. INSTALL REAR DOOR QUARTER WINDOW GLASS

   Click here

5. INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

   Click here

6. INSTALL REAR DOOR GLASS RUN

   Click here

7. CONNECT REAR DOOR WEATHERSTRIP

   
   

   1. 

      Connect the rear door weatherstrip as shown in the illustration.

8. INSTALL REAR DOOR SERVICE HOLE COVER

   Click here

9. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

   Click here

10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

11. INSTALL REAR DOOR NO. 1 STIFFENER CUSHION

    Click here

12. INSTALL REAR DOOR NO. 3 ARMREST COVER

    Click here

13. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

14. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

15. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

16. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

17. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

18. INSPECT POWER WINDOW OPERATION

    Click here