POWER WINDOW REGULATOR MOTOR(for Rear Door) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure described below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative(-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  5. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  6. REMOVE REAR DOOR NO. 3 ARMREST COVER

    Click here

  7. REMOVE REAR DOOR NO. 1 STIFFENER CUSHION

    Click here

  8. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  9. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

  10. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

  11. DISCONNECT REAR DOOR WEATHERSTRIP


    1. A00227N

      Disconnect the rear door weatherstrip as shown in the illustration.

  12. REMOVE REAR DOOR GLASS RUN

    Click here

  13. REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

    Click here

  14. REMOVE REAR DOOR QUARTER WINDOW GLASS

    Click here

  15. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  16. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY

    Click here

  17. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY


    1. A00230S

      Using a T25 "TORX" socket wrench, remove the 3 screws and rear power window regulator motor assembly.