POWER WINDOW REGULATOR MOTOR(for Front Door) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY

   Note

   The regulator arm must be below the intermediate position when installing the power window regulator motor assembly.

   
   

   1. 

      Using a T25 "TORX" socket wrench, install the front power window regulator motor assembly with the 3 screws.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      When replacing a front power window regulator motor assembly, a new front power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

2. INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY

   Click here

3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

   Click here

4. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY

   Click here

5. INSTALL FRONT DOOR SERVICE HOLE COVER

   Click here

6. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP

   Click here

7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

   Click here

8. INSTALL FRONT DOOR NO. 1 STIFFENER CUSHION

   Click here

9. INSTALL COURTESY LIGHT ASSEMBLY

   Click here

10. INSTALL FRONT DOOR ARMREST COVER

    Click here

11. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

12. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

13. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

14. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

15. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

16. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

17. INSPECT POWER WINDOW OPERATION

    Click here