FRONT EVAPORATOR TEMPERATURE SENSOR

INSTALL NO. 1 COOLER THERMISTOR

*a	Fixed Part
*b	Sensor Part

Install the No. 1 cooler thermistor as shown in the illustration.

Part	Length
A	101.3 mm (3.99 in.)
B	50.0 mm (1.97 in.)

Note

Be sure to insert the No. 1 cooler thermistor only once because reinserting it into the same position will not allow it to be firmly secured.
When reusing the No. 1 cooler evaporator sub-assembly, insert the No. 1 cooler thermistor one row next to the one that has been used previously (X in the illustration).
After inserting the No. 1 cooler thermistor, do not apply excessive force to the wire.
Directly insert the No. 1 cooler thermistor until the edge of the plastic case "a" comes into contact with the No. 1 cooler evaporator sub-assembly "b".

INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

INSTALL NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for LH Side)

INSTALL NO. 4 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY

INSTALL NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for RH Side)

INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY

INSTALL COOLER EXPANSION VALVE