SEAT MEMORY SWITCH INSPECTION

PROCEDURE


  1. INSPECT SEAT MEMORY SWITCH (DRIVER DOOR)


    1. A01MSGJC01
      *A for LHD
      *B for RHD
      *a M1 Switch
      *b M2 Switch
      *c M3 Switch
      *d SET Switch
      *e

      Component without harness connected

      (Seat Memory Switch (Driver Door))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 5 M1 switch pressed Below 100 Ω
      M1 switch not pressed 1 MΩ or higher
      2 - 5 M2 switch pressed Below 100 Ω
      M2 switch not pressed 1 MΩ or higher
      3 - 5 M3 switch pressed Below 100 Ω
      M3 switch not pressed 1 MΩ or higher
      4 - 5 SET switch pressed Below 100 Ω
      SET switch not pressed 1 MΩ or higher

      If the result is not as specified, replace the seat memory switch (driver door).