PRE-CRASH SAFETY SYSTEM CANCEL SWITCH INSPECTION

PROCEDURE


  1. INSPECT PRE-CRASH SYSTEM CANCEL SWITCH ASSEMBLY


    1. A011QCOC02
      *a

      Component without harness connected

      (Pre-crash Safety System Cancel Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      1 - 2 Pressed Below 1 Ω
      1 - 2 Not pressed 10 kΩ or higher

      If the result is not as specified, replace the pre-crash safety system cancel switch assembly.