Click here

PRE-CRASH SAFETY SYSTEM, Diagnostic DTC:C1A10

Click here
Click here
DTC Code DTC Name
C1A10 Front Radar Sensor
Click here

DESCRIPTION

The driving support ECU assembly uses the millimeter wave radar sensor assembly to detect obstacles in front of the vehicle.

Based on this information, the driving support ECU assembly sends pre-crash safety control operation signals.

When the driving support ECU assembly receives information that there is a malfunction in the millimeter wave radar sensor assembly, DTC C1A10 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A10 Front Radar Sensor When the power switch is on (IG), the driving support ECU assembly receives information that there is a malfunction in the millimeter wave radar sensor assembly for approximately 2 seconds.

  • Millimeter wave radar sensor assembly

  • Driving support ECU assembly
Click here

CAUTION / NOTICE / HINT

Note:

When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

Click here

Click here

PROCEDURE


  1. Click here

    REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY


    1. Replace the millimeter wave radar sensor assembly with a new one.

      Click here

    2. Perform millimeter wave radar sensor assembly adjustment.

      Click here

      Result
      Proceed to
      NEXT

  2. Click here

    CHECK FOR DTCs (PRE-CRASH 2)


    1. Clear the DTCs.

      Click here


      1. Body Electrical > Pre-Crash 2 > Clear DTCs


    2. Make sure that the DTC detection conditions are met.

      Tip:

      If the detection conditions are not met, the system cannot detect the malfunction.

    3. Check for DTCs.

      Click here


      1. Body Electrical > Pre-Crash 2 > Trouble Codes


      Note:

      When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.

      Result
      Result Proceed to
      DTC C1A10 is not output A
      DTC C1A10 is output B

    • A

      END (MILLIMETER WAVE RADAR SENSOR ASSEMBLY WAS DEFECTIVE)

    • B

      REPLACE DRIVING SUPPORT ECU ASSEMBLYClick here