POP UP HOOD SENSOR REMOVAL

PROCEDURE

1. REMOVE FRONT BUMPER ASSEMBLY

   for Sport Package: Click here

   for Standard: Click here

2. REMOVE FRONT BUMPER ENERGY ABSORBER

   for Sport Package: Click here

   for Standard: Click here

3. REMOVE PEDESTRIAN PROTECTION SENSOR

   Note

   When removing the pop up hood sensor assembly to inspect it, do not remove the pedestrian protection sensor, or seal of the pedestrian detection chamber may be damaged.

   
   

   1. Check that the power switch is off.

   2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   3. Disconnect the 2 connectors from the pop up hood sensor assembly.

      Note

      When disconnecting any pedestrian protection sensor connector, take care not to damage the airbag wire harness.

      
      

      1. Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

         

         *a	White Housing Lock	*b	Yellow CPA
         *c	Connector lock is released	-	-

      2. Push down the white housing lock again and disconnect the connector.

         Note

         Do not push down the part (A) shown in the illustration when disconnecting the connector.

   4. Remove the 6 bolts and 3 clips to remove the pop up hood sensor assembly from the vehicle body.

      

   5. After disconnecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

      

      *a

      Incorrect

      *b

      Correct

   6. 

      Remove the bolt and pedestrian protection sensor from the pedestrian detection chamber.

      Tech Tips

      Use the same procedure for the other side.