REAR AIRBAG SENSOR REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   PRECAUTION

   CAUTION:

   Be sure to read Precaution thoroughly before servicing.

   Click here

   Note:

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

   Click here

2. Click here

   REMOVE BATTERY SERVICE HOLE COVER LH

   Click here

3. Click here

   DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

4. Click here

   REMOVE REAR SEAT ASSEMBLY (for Fixed Seat Type)

   Click here

5. Click here

   REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)

   Click here

6. Click here

   REMOVE REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type)

   Click here

7. Click here

   REMOVE REAR SIDE SEATBACK ASSEMBLY (for Fold Down Seat Type)

   Click here

8. Click here

   REMOVE REAR DOOR SCUFF PLATE

   Click here

9. Click here

   REMOVE REAR SEAT SIDE GARNISH

   Click here

10. Click here

    REMOVE REAR AIRBAG SENSOR

    
    

    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

       CAUTION:

       Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. Disconnect the connector from the rear airbag sensor.

       Note:

       When disconnecting any airbag connector, take care not to damage the airbag wire harness.

       
       
       1. 

          *a	White Housing Lock	*b	Yellow CPA
          *c	Slide	*d	Push

          Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

       2. Push down the white housing lock again and disconnect the connector.

          Note:

          Do not push down the part (A) shown in the illustration when disconnecting the connector.

    4. 

       Remove the bolt and rear airbag sensor from the vehicle body.

       Note:

       Loosen the bolt while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.

    5. 

       *a

       Correct

       *b

       Incorrect

       After disconnecting the connector, check that the position of the white housing lock is correct as shown in the illustration.