FRONT AIRBAG SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY

    for Sport Package: Click here

    for Standard: Click here

  2. REMOVE UPPER FRONT FENDER PROTECTOR

    Click here

  3. REMOVE HEADLIGHT ASSEMBLY

    for HID Headlight: Click here

    for LED Headlight: Click here

  4. REMOVE FRONT AIRBAG SENSOR


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. Disconnect the connector from the front airbag sensor.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.


      1. Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

        B003YIJC08
        *a White Housing Lock *b Yellow CPA
        *c Connector lock is released - -

      2. Push down the white housing lock again and disconnect the connector.

        Note

        Do not push down the part (A) shown in the illustration when disconnecting the connector.

    4. A0021IB

      Remove the 2 bolts.

      Note

      Loosen the bolts while holding the front airbag sensor because the front airbag sensor pin (stopper) is easily damaged.

    5. Disengage the 2 claws to remove the front airbag sensor from the vehicle body.

    6. After disconnecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

      B003Y7JC01
      *a Incorrect *b Correct