KNEE AIRBAG ASSEMBLY(for Driver Side) INSTALLATION

PROCEDURE

1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

   
   

   1. Check that the power switch is off.

   2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   3. 

      *a	Airbag Connector
      *b	Airbag Connector Lock
      *c	DLC3

      Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

   4. Push in the airbag connector lock to install the airbag connector.

   5. Engage the 2 claws to connect the DLC3.

   6. Engage the 2 pins and clamp to temporarily install the lower No. 1 instrument panel airbag assembly.

   7. Install the 4 bolts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

2. INSTALL SKID CONTROL BUZZER ASSEMBLY (w/ Pre-crash Safety System)

   Click here

3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

   Click here

4. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   Click here

5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

6. INSTALL INSTRUMENT SIDE PANEL LH

   Click here

7. INSTALL FRONT DOOR OPENING TRIM COVER LH

   Click here

8. INSTALL FRONT DOOR SCUFF PLATE LH

   Click here

9. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

10. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

11. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

12. INSPECT SRS WARNING LIGHT

    Click here