STEERING PAD INSTALLATION

PROCEDURE

1. INSTALL HORN BUTTON ASSEMBLY

   
   

   1. Check that the power switch is off.

   2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   3. 

      *a	Airbag Connector
      *b	Horn Connector
      *c	Airbag Connector Lock

      Connect the 2 airbag connectors to the horn button assembly.

      Note

      
      

      • When connecting any airbag connector, take care not to damage the airbag wire harness.

      • Be sure to only connect the connectors to each corresponding color.

   4. Push in the 2 airbag connector locks to install the 2 airbag connectors.

   5. Connect the horn connector to the horn button assembly.

   6. 

      Push the horn button assembly to engage the 3 pins carefully.

      Note

      
      

      • Make sure that the pins are securely inserted into the steering wheel assembly holes.

      • Make sure to engage the 2 upper pins first.

      • Make sure that the horn button assembly is securely installed.

2. INSTALL LOWER NO. 3 STEERING WHEEL COVER

   

   
   

   1. Insert the guide and engage the claw to install the lower No. 3 steering wheel cover.

3. INSTALL LOWER NO. 2 STEERING WHEEL COVER

   

   
   

   1. Insert the guide and engage the claw to install the lower No. 2 steering wheel cover.

4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

5. INSTALL BATTERY SERVICE HOLE COVER LH

   Click here

6. INSPECT HORN BUTTON ASSEMBLY

   
   

   1. Make sure that the horn sounds.

      If the horn does not sound, inspect the horn system.

      Click here

7. PERFORM DIAGNOSTIC SYSTEM CHECK

   Click here

8. INSPECT SRS WARNING LIGHT

   Click here