DESCRIPTION
The pedestrian detection sensor LH circuit consists of the airbag sensor assembly and pedestrian protection sensor LH.
The pedestrian protection sensor LH detects impacts to the vehicle and sends signals to the airbag sensor assembly to determine if the pop up hood should be deployed.
DTC B16A5/94 is stored when a malfunction is detected in the pedestrian protection sensor LH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Test Mode / Check Mode |
|---|---|---|---|---|
| B16A5/94 | Pedestrian Detection Sensor LH Circuit |
|
|
Does not apply to test/check mode |
WIRING DIAGRAM
CAUTION / NOTICE / HINT
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
PROCEDURE
REPLACE PEDESTRIAN PROTECTION SENSOR LH
Turn the power switch off.
Disconnect the cable from the negative (-) auxiliary battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Replace the pedestrian protection sensor LH with a new one.
Connect the cable to the negative (-) auxiliary battery terminal.
| Result | ||
|---|---|---|
|
| NEXT |
|
CHECK DTC
Clear the DTCs stored in memory.
Turn the power switch off.
Turn the power switch on (IG), and wait for at least 60 seconds.
Check for DTCs.
| OK |
|---|
| DTC B16A5/94 is not output. |
Tech Tips
Codes other than DTC B16A5/94 may be output at this time, but they are not related to this check.
| Result | |||
|---|---|---|---|
|
| OK |
|
END (PEDESTRIAN PROTECTION SENSOR LH WAS DEFECTIVE) |
| NG |
|
REPLACE AIRBAG SENSOR ASSEMBLY Click here |