CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

    Note

    When installing a curtain shield airbag assembly, have assistants hold it to prevent it from bending.


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. Install 4 new bolts and 4 new clips, and engage the 4 hooks and 5 clips in the order shown in the illustration.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

      Note

      Do not twist the curtain shield airbag assembly when installing it.

      Tech Tips

      Engage the 2 claws to install a new clip.

      A0021A5C01
      *1 Pin - -
      *a Clip - -

    4. Push in 4 new pins to each clip.

      Note

      Make sure that the pins of the clips are pushed in firmly.

    5. A0022T5C01
      *a Airbag Connector
      *b Airbag Connector Lock

      Connect the airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    6. Push in the airbag connector lock to install the airbag connector.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Click here

  3. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here