FRONT PASSENGER AIRBAG ASSEMBLY INSTALLATION

PROCEDURE

1. INSTALL NO. 2 INSTRUMENT PANEL WIRE

   
   
   1. 

      *a	Airbag Connector
      *b	Airbag Connector Lock

      Connect the 2 airbag connectors of the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.

      Note

      
      

      • When connecting any airbag connector, take care not to damage the airbag wire harness.

      • Be sure to only connect the connectors to each corresponding color.

   2. Push in the 2 airbag connector locks to install the 2 airbag connectors to the instrument panel passenger airbag assembly.

   3. Engage the clamp.

2. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

   
   

   1. Engage the 3 hooks.

   2. Push in the instrument panel passenger airbag assembly to engage the 3 hooks.

   3. Install the instrument panel passenger airbag assembly with the 2 screws.

3. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

   Click here

4. CONNECT NO. 2 INSTRUMENT PANEL WIRE

   
   

   1. Check that the power switch is off.

   2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   3. 

      Connect the connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

5. INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT

   Click here