SLIDING ROOF SWITCH ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT SLIDING ROOF SWITCH (MAP LIGHT ASSEMBLY)


    1. A011M5AC01
      *a

      Component without harness connected

      (Sliding Roof Switch (Map Light Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      23 - 19 UP switch is pressed Below 1 Ω
      23 - 19 UP switch is not pressed 10 kΩ or higher
      24 - 19 DOWN switch is pressed Below 1 Ω
      24 - 19 DOWN switch is not pressed 10 kΩ or higher
      11 - 19 OPEN switch is pressed Below 1 Ω
      11 - 19 OPEN switch is not pressed 10 kΩ or higher
      12 - 19 CLOSE switch is pressed Below 1 Ω
      12 - 19 CLOSE switch is not pressed 10 kΩ or higher
      1 - 13 Always Below 1 Ω

      If the result is not as specified, replace the sliding roof switch (map light assembly).