SLIDING ROOF HOUSING REASSEMBLY

PROCEDURE


  1. INSTALL ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY


    1. Engage the 2 guides as shown in the illustration to install the roof wind deflector panel sub-assembly.

      A011MOP

    2. Engage the 2 springs as shown in the illustration.

      A011M5SC03
      *a Spring - -

      Note

      Make sure that the springs are securely installed.

  2. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY


    1. A011QBF

      Hold down the roof wind deflector panel sub-assembly.

    2. Using a screwdriver, slide the sliding roof drive cable sub-assembly as shown in the illustration to install it.

      A011PXHC03
      *a Protective Tape - -

      Tech Tips

      Tape the screwdriver tip before use.

  3. INSTALL REAR ROOF DRIP CHANNEL


    1. Insert the rear roof drip channel in the direction indicated by the arrow (1) in the illustration.

      A011PL9N01

    2. Engage the 2 claws in the direction indicated by the arrow (2) in the illustration to install the rear roof drip channel.

  4. ADJUST FULLY CLOSED POSITION


    1. Using a screwdriver, slide the sliding roof drive cable sub-assembly in either direction as shown in the illustration and alignment marks.

      A011QI2C03
      *a Alignment Mark - -

      Tech Tips

      Tape the screwdriver tip before use.

  5. INSTALL SUNSHADE TRIM SUB-ASSEMBLY


    1. A011PDS

      Insert the sunshade trim sub-assembly into the sliding roof housing sub-assembly.

    2. Engage the guide to install the sliding roof piece sub-assembly LH.

      A011MZB

      Tech Tips

      Use the same procedure for the RH side.

    3. Install the 2 screws.

  6. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. A011PUA

      Install the sliding roof drive gear sub-assembly with the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }
    2. A011PE7C03
      *a Guide
      *b Pin

      Engage the guide and pin.

    3. Engage the claw to install the map light bracket.