REPAIR INSTRUCTION INITIALIZATION


  1. PROCEDURES NECESSARY WHEN AUXILIARY BATTERY TERMINAL IS DISCONNECTED/RECONNECTED

    Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
    Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

    Click here

    Pre-collision system
    Parking assist monitor system

    Click here w/ Parallel Parking Assist Function

    Click here w/o Parallel Parking Assist Function
    Servo motor initialization Air conditioning system

    Click here

    Note


    • After the engine switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal (w/ Navigation System).

    • After the power switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds (w/ Parallel Parking Assist Function) or 90 seconds (w/o Parallel Parking Assist Function) before disconnecting the cable from the negative (-) battery terminal (w/o Navigation System).

  2. PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED

    Replacement Part Necessary Procedure Effect / Inoperative Function when Necessary Procedures are not Performed Link
    ECM Perform Vehicle Identification Number (VIN) or frame number registration MIL comes on

    Click here*1

    Click here*2

    • Throttle body with motor assembly

    • Cleaning the deposits from the throttle body with motor assembly

    • Engine assembly

    • Cylinder head sub-assembly

    • Camshaft (for intake or exhaust camshaft)

    • Camshaft timing gear assembly

    • Camshaft timing exhaust gear assembly

    • Piston or piston ring

    • Mass air flow meter sub-assembly

    • Fuel injector assembly (for direct injection)

    • Fuel injector assembly (for port injection)

    • Fuel pump (for high pressure)

    • Fuel pump (for low pressure)

    • Air fuel ratio sensor

    • Engine coolant temperature sensor

    • Spark plug

    • Ignition coil assembly

    • EGR valve assembly*1

    • Air leaks from intake system

    • Gas leaks from exhaust system

    • Knock control sensor

    		 Inspection after repair Poor idle, engine start, etc.

    Click here*1

    Click here*2
    Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly

    • Dynamic radar cruise control system

    • Pre-collision system

    • Forward recognition camera system

    • Lane departure alert system (w/ Steering Control)

    • Road sign assist system

    Click here


    • Forward recognition camera

    • Windshield glass

    		 Adjust forward recognition camera

    • Dynamic radar cruise control system

    • Lane departure alert system (w/ Steering Control)

    • Pre-collision system

    • Forward recognition camera system

    • Road sign assist system

    • Automatic high beam system

    Click here

    Absorber control ECU Perform registration of vehicle identification information

    • Interrupts damping force control after moving to the 9th step.

    • DTCs are output

    Click here


    • Tire pressure warning ECU and receiver

    • Tire pressure warning valve and transmitter

    • Transmitter ID registration

    • Initialization

    • When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

    • Tire pressure warning function

    Click here for Initialization

    Click here for Registration
    Skid control ECU assembly

    • Clear stored linear solenoid valve calibration data

    • Perform initialization and calibration of the linear solenoid valve

    • Perform yaw rate and acceleration sensor zero point calibration

    • DTCs are output

    • ABS warning light illumination

    • Brake warning light/yellow (minor malfunction) illumination

    • Slip indicator light illumination

    • VSC disable or malfunctioning

    Click here for Initialization

    Click here for calibration

    • Brake pedal stroke sensor assembly

    • Brake pedal

    • Clear stored linear solenoid valve calibration data

    • Perform initialization and calibration of the linear solenoid valve
    Brake actuator assembly

    • Bleed air

    • Clear stored linear solenoid valve calibration data

    • Perform initialization and calibration of the linear solenoid valve
    Yaw rate and acceleration sensor

    • Clear stored linear solenoid valve calibration data or clear zero point calibration data

    • Perform initialization and calibration of the linear solenoid valve

    • Perform yaw rate and acceleration sensor zero point calibration

    • Power steering ECU assembly

    • Power steering link assembly

    		 Perform rotation angle sensor initialization and torque sensor zero point calibration

    • DTCs are output

    • Steering effort different between turning steering wheel left and right

    Click here

    Power steering ECU assembly Assist map writing

    • DTCs are output

    • EPS warning light illuminated
    Telematics transceiver Register vehicle information Emergency call service

    Click here

    Mobilephone battery Reset mobilephone battery condition
    Radio receiver assembly Parking assist monitor system initialization Parking assist monitor system (w/ Parallel Parking Assist Function)

    Click here for Initialization

    Click here for Calibration
    Spiral cable with sensor sub-assembly

    • Steering angle neutral point (Initialize parking assist monitor system)

    • Steering angle setting

    • Suspension, tires, etc.

    • Rear television camera assembly

    		 Rear television camera assembly optical axis (Back camera position setting)
    Spiral cable with sensor sub-assembly

    • Steering angle neutral point (Initialize parking assist monitor system)

    • Steering angle setting

    		 Parking assist monitor system (w/o Parallel Parking Assist Function)

    Click here for Initialization

    Click here for Calibration
    Suspension, tires, etc. Rear television camera assembly optical axis (Back camera position setting)
    Rear television camera assembly

    • Parking assist monitor system initialization

    • Rear television camera assembly optical axis (Back camera position setting)
    Blind spot monitor sensor Blind spot monitor beam axis inspection DTCs are output

    Click here


    • Inner rear view mirror assembly

    • Garage door opener transmitter

    Re-registration of codes in the garage door opener system


    • Register transmitter code

    • Rolling code systems

    		 Garage door opener system

    Click here

    Hybrid vehicle control ECU ECU communication ID registration (Immobiliser system)

    • Entry and start system

    • Immobiliser system

    		 See Service Bulletin for the registration method.

    • Certification ECU (smart key ECU assembly)

    • ID code box (immobiliser code ECU)

    • Electrical key transmitter sub-assembly

    • Steering lock ECU (steering lock actuator assembly)

    		 Code registration (Immobiliser system)

    • Wireless door lock control system

    • Entry and start system

    • Push-button start

    • Immobiliser system

    • Steering lock system

    • No. 1 air conditioning radiator damper servo sub-assembly

    • No. 2 air conditioning radiator damper servo sub-assembly (driver side)

    • No. 2 air conditioning radiator damper servo sub-assembly (front passenger side)

    • No. 3 air conditioning radiator damper servo sub-assembly

    • No. 4 air conditioning radiator damper servo sub-assembly

    • No. 5 air conditioning radiator damper servo sub-assembly

    • No. 6 air conditioning radiator damper servo sub-assembly (for dual type)

    • No. 1 blower damper servo sub-assembly

    		 Initialization servo motor (Air conditioning system) DTCs are output

    Click here


    • Door window regulator assembly

    • Power window regulator motor assembly

    • Door glass

    • Door glass run

    		 Initialize power window control system

    • Auto up and down function

    • Jam protection function

    • Remote control function

    • Key-linked function

    • Wireless transmitter-linked function

    • Key-off operation function

    • Window open warning function

    Click here


    • Sliding roof ECU (sliding roof drive gear sub-assembly)

    • Sliding roof glass sub-assembly

    • Sliding roof drive cable sub-assembly

    		 Initialize sliding roof system

    • Auto operation function

    • Jam protection function

    • Key-off operation function

    • Key-linked function

    • Wireless transmitter-linked function

    • Sliding roof open warning function

    Click here

    No. 1 headlight ECU sub-assembly LH

    • Synchronize vehicle information

    • Initialize No. 1 headlight ECU sub-assembly LH

    		 Automatic headlight beam level control system

    Click here


    • Rear height control sensor sub-assembly LH

    • Suspension, tires, etc.*3

    		 Initialize No. 1 headlight ECU sub-assembly LH

    • *1: w/ EGR System

    • *2: w/o EGR System

    • *3: The vehicle height changes because of suspension or tire replacement