REAR BUMPER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips

If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dentedor bent.

Click here

If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.

PROCEDURE


  1. REMOVE NO. 1 REAR BUMPER PLATE


    1. A001KXNC02
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the No. 1 rear bumper plate.

      Tech Tips

      Use the same procedure for the RH side and LH side.

  2. REMOVE REAR BUMPER ASSEMBLY


    1. A001KW1C02
      B003V9P Protective Tape

      Apply protective tape around the rear bumper assembly as shown in the illustration.

    2. A001HSF

      Remove the 2 screws.

    3. A001HSA

      Remove the 6 clips.

    4. A001JW0

      Remove the screw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    5. A001KMO

      Disengage the claw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    6. A001JZU

      Disengage the 5 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    7. A001JWJ

      Disengage the 8 claws and remove the rear bumper assembly as shown in the illustration.

    8. w/ Intuitive Parking Assist System:


      1. Disconnect the connector.