FRONT DOOR BELT MOULDING REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   Note

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

   Click here

4. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

   Click here

5. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

   Click here

6. REMOVE FRONT DOOR ARMREST COVER

   Click here

7. REMOVE COURTESY LIGHT ASSEMBLY

   Click here

8. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION

   Click here

9. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

   Click here

10. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP

    Click here

11. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

    Click here

12. REMOVE FRONT DOOR FRONT LOWER FRAME UPPER COVER

    Click here

13. REMOVE FRONT DOOR SERVICE HOLE COVER

    Click here

14. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

15. REMOVE FRONT DOOR GLASS RUN

    Click here

16. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY

    
    

    1. 

       Protective Tape

       Apply protective tape around the front door belt moulding assembly.

    2. 

       *a	Protective Tape

       Using a screwdriver with its tip wrapped with protective tape, disengage the 6 claws and remove the front door belt moulding assembly.