REAR COMBINATION LIGHT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY


    1. Engage the grommet.

    2. Connect the connector to install the rear combination light socket and wire sub-assembly.

  2. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  3. INSTALL LUGGAGE COMPARTMENT TRIM COVER RH (for RH Side)

    Click here

  4. INSTALL NO. 2 ROOM PARTITION COVER (for Fold Down Seat Type)

    Click here

  5. INSTALL REAR SEAT SUB FLOOR PANEL (for Fold Down Seat Type)

    Click here

  6. INSTALL REAR SEAT ASSEMBLY (for Fixed Seat Type)

    Click here

  7. INSTALL REAR SEAT ASSEMBLY (for Fold Down Seat Type)

    Click here

  8. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER

    for Fixed Seat Type: Click here

    for Fold Down Seat Type: Click here

  9. INSTALL REAR LUGGAGE COMPARTMENT TRIM COVER

    Click here

  10. INSTALL DECK SIDE TRIM BOX RH

    Click here

  11. INSTALL DECK SIDE TRIM BOX LH

    Click here

  12. INSTALL SPARE WHEEL COVER TRAY (w/o Spare Tire)

    Click here

  13. INSTALL SPARE WHEEL COVER TRAY LH (w/ Spare Tire)

    Click here

  14. INSTALL SPARE WHEEL COVER TRAY RH (w/ Spare Tire)

    Click here

  15. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  16. INSTALL REAR BUMPER UPPER RETAINER


    1. Engage the guide.

    2. Install the rear bumper upper retainer with the screw.

    3. Engage the clamp.

  17. INSTALL REAR BUMPER ASSEMBLY

    Click here

  18. INSTALL REAR TURN SIGNAL LIGHT BULB


    1. Install the rear turn signal light bulb to the rear combination light socket and wire sub-assembly.

  19. INSTALL REAR COMBINATION LIGHT ASSEMBLY


    1. Connect the connector.

    2. A01270ZC03
      *a Cap

      Turn the cap as shown in the illustration to connect it.

    3. A0127O2

      Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb as shown in the illustration to connect them as a unit.

    4. A0127AYC02
      *a Pin
      *b Guide

      Engage the 3 guides and pin to temporarily install the rear combination light assembly as shown in the illustration.

    5. Install the rear combination light assembly with the 2 screws.

      Torque:
      2.2 N*m  { 22 kgf*cm, 19 in.*lbf }

    6. Remove the protective tape.

  20. INSTALL REAR LIGHT COVER


    1. A0126FP

      Engage the 6 claws to install the 2 rear light covers.