REAR COMBINATION LIGHT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR COMBINATION LIGHT COVER


    1. B003WDX

      Using a moulding remover, disengage the 4 claws to remove the rear combination light cover as shown in the illustration.

  2. REMOVE REAR COMBINATION LIGHT ASSEMBLY


    1. B003SW7C01
      B003V9P Protective Tape

      Apply protective tape around the rear combination light assembly as shown in the illustration.

    2. B003TD6C01
      *a Pin
      *b Guide

      Remove the 2 screws.

    3. Push the rear combination light assembly toward the rear of the vehicle to disengage the pin.

      Note

      To prevent the rear combination light assembly from springing out and falling when it is disengaged, place your hand on the rear combination light assembly and press down gently.

      Tech Tips

      Pushing on the portion A in the illustration toward the rear of the vehicle will make disengagement of the pin easier.

    4. Disengage the 3 guides to separate the rear combination light assembly as shown in the illustration.

    5. for Bulb Type Turn Signal Light:


      1. B003VZ8

        Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.

    6. B003VW9C01
      *a Cap

      Turn the cap as shown in the illustration to disconnect it.

    7. Disconnect the connector to remove the rear combination light assembly.

  3. REMOVE REAR TURN SIGNAL LIGHT BULB (for Bulb Type Turn Signal Light)


    1. Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.

  4. REMOVE REAR BUMPER ASSEMBLY

    Click here

  5. REMOVE REAR BUMPER UPPER RETAINER


    1. B003TB9C01
      *a Clamp
      *b Guide

      Disengage the clamp.

    2. Remove the screw.

    3. Disengage the guide to remove the rear bumper upper retainer.

  6. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  7. REMOVE SPARE WHEEL COVER TRAY (w/o Spare Tire)

    Click here

  8. REMOVE SPARE WHEEL COVER TRAY LH (w/ Spare Tire)

    Click here

  9. REMOVE SPARE WHEEL COVER TRAY RH (w/ Spare Tire)

    Click here

  10. REMOVE DECK SIDE TRIM BOX LH

    Click here

  11. REMOVE DECK SIDE TRIM BOX RH

    Click here

  12. REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER

    Click here

  13. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER

    for Fixed Seat Type: Click here

    for Fold Down Seat Type: Click here

  14. REMOVE REAR SEAT ASSEMBLY (for Fixed Seat Type)

    Click here

  15. REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type)

    Click here

  16. REMOVE REAR SEAT SUB FLOOR PANEL (for Fold Down Seat Type)

    Click here

  17. REMOVE NO. 2 ROOM PARTITION COVER (for Fold Down Seat Type)

    Click here

  18. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH (for LH Side)

    Click here

  19. REMOVE LUGGAGE COMPARTMENT TRIM COVER RH (for RH Side)

    Click here

  20. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY


    1. B003T65

      Disconnect the connector.

    2. Disengage the grommet to remove the rear combination light socket and wire sub-assembly.