HEADLIGHT ASSEMBLY(for LED Type Turn Signal Light) INSPECTION

PROCEDURE


  1. INSPECT HEADLIGHT UNIT

    A001HWVC01
    *1 Headlight Unit (Headlight Cord) - -
    *a

    Component without harness connected

    (to No. 1 Headlight ECU Sub-assembly LH)

    		 *b

    Component without harness connected

    (to No. 1 Headlight ECU Sub-assembly LH)
    *c

    Component without harness connected

    (to Headlight Leveling Motor)

    		 *d

    Component without harness connected

    (to Headlight Unit Assembly (Lo Beam))
    *e

    Component without harness connected

    (to Headlight Unit Assembly (Hi Beam))

    		 *f

    Component without harness connected

    (to Headlight Unit Assembly (Headlight Fan))
    *g

    Component without harness connected

    (to Headlight LED Unit Assembly)

    		 - -

    1. Measure the resistance according to the value(s) in the table below.


      1. Inspect the headlight leveling motor circuit.

        Standard Resistance
        Tester Connection Condition Specified Condition
        B-7 (ACTBI) - P-3 Always Below 1 Ω
        B-8 (ACTSI) - P-2 Always Below 1 Ω
        B-17 (ACTGI) - P-1 Always Below 1 Ω

        If the result is not as specified, replace the headlight unit (headlight cord).

      2. Inspect the low beam headlight circuit.

        Standard Resistance
        Tester Connection Condition Specified Condition
        B-4 (LOLED2) - E-2 Always Below 1 Ω
        B-5 (LOLED1) - E-1 Always Below 1 Ω

        If the result is not as specified, replace the headlight unit (headlight cord).

      3. Inspect the high beam headlight circuit.

        Standard Resistance
        Tester Connection Condition Specified Condition
        C-8 (HILED2) - F-2 Always Below 1 Ω
        C-9 (HILED1) - F-1 Always Below 1 Ω

        If the result is not as specified, replace the headlight unit (headlight cord).

      4. Inspect the headlight fan circuit.

        Standard Resistance
        Tester Connection Condition Specified Condition
        B-6 (FANB) - G-1 Always Below 1 Ω
        B-14 (FANG) - G-2 Always Below 1 Ω
        B-15 (FANP) - G-3 Always Below 1 Ω

        If the result is not as specified, replace the headlight unit (headlight cord).

      5. Inspect the turn signal light circuit.

        Standard Resistance
        Tester Connection Condition Specified Condition
        B-9 (TURN+) - H-1 Always Below 1 Ω
        B-13 (TURN-) - H-2 Always Below 1 Ω

        If the result is not as specified, replace the headlight unit (headlight cord).

  2. INSPECT HEADLIGHT LED UNIT ASSEMBLY

    A001JXRC51
    *a

    Component without harness connected

    (to Headlight LED Unit Assembly)

    1. Apply battery voltage to the headlight LED unit assembly and check that the light illuminates.

      OK
      Condition Specified Condition

      Battery positive (+) → Terminal 1

      Battery negative (-) → Terminal 2

      		 Turn signal light illuminates

      If the result is not as specified, replace the headlight LED unit assembly.