NETWORK GATEWAY ECU INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL NETWORK GATEWAY ECU


    1. B003SZO

      Insert the hole of the network gateway into the pin of the blower assembly.

    2. Install the 2 bolt.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    3. Connect the network gateway ECU connector.

  2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  3. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  5. INSTALL INSTRUMENT SIDE PANEL RH (for LHD)

    Click here

  6. INSTALL INSTRUMENT SIDE PANEL LH (for RHD)

    Click here

  7. INSTALL FRONT DOOR OPENING TRIM COVER RH (for LHD)

    Click here

  8. INSTALL FRONT DOOR OPENING TRIM COVER LH (for RHD)

    Click here

  9. INSTALL FRONT DOOR SCUFF PLATE RH (for LHD)

    Click here

  10. INSTALL FRONT DOOR SCUFF PLATE LH (for RHD)

    Click here

  11. INSTALL FRONT NO. 2 CONSOLE BOX INSERT (for LHD)

    Click here

  12. INSTALL FRONT NO. 1 CONSOLE BOX INSERT (for RHD)

    Click here

  13. INSTALL INSTRUMENT PANEL FINISH PANEL END RH (for LHD)

    Click here

  14. INSTALL INSTRUMENT PANEL FINISH PANEL END LH (for RHD)

    Click here

  15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here