REAR POWER WINDOW SWITCH INSPECTION

PROCEDURE


  1. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for LH Door)


    1. A0125SRC07
      *a

      Component without harness connected

      (Rear Power Window Regulator Switch Assembly (for LH Door))

      Check the switch function.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        2 (UP) - 5 (GND) Auto up or up position Below 1 Ω
        10 (DOWN) - 5 (GND) Auto down or down position Below 1 Ω
        4 (AUTO) - 5 (GND) Auto up or auto down position Below 1 Ω
        2 (UP) - 5 (GND) Off 10 kΩ or higher
        10 (DOWN) - 5 (GND) Off 10 kΩ or higher
        4 (AUTO) - 5 (GND) Off 10 kΩ or higher

        If the result is not as specified, replace the rear power window regulator switch assembly (for LH door).

    2. A0125SRC08
      *a

      Component without harness connected

      (Rear Power Window Regulator Switch Assembly (for LH Door))

      Check that the LED illuminates.


      1. Apply battery voltage to the rear power window regulator switch assembly and check that the LED illuminates.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 8 (LED)

        Battery negative (-) → 5 (GND)

        LED illuminates

        If the result is not as specified, replace the rear power window regulator switch assembly (for LH door).

  2. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for RH Door)


    1. A0125SRC07
      *a

      Component without harness connected

      (Rear Power Window Regulator Switch Assembly (for RH Door))

      Check the switch function.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        2 (UP) - 5 (GND) Auto up or up position Below 1 Ω
        10 (DOWN) - 5 (GND) Auto down or down position Below 1 Ω
        4 (AUTO) - 5 (GND) Auto up or auto down position Below 1 Ω
        2 (UP) - 5 (GND) Off 10 kΩ or higher
        10 (DOWN) - 5 (GND) Off 10 kΩ or higher
        4 (AUTO) - 5 (GND) Off 10 kΩ or higher

        If the result is not as specified, replace the rear power window regulator switch assembly (for RH door).

    2. A0125SRC08
      *a

      Component without harness connected

      (Rear Power Window Regulator Switch Assembly (for RH Door))

      Check that the LED illuminates.


      1. Apply battery voltage to the rear power window regulator switch assembly and check that the LED illuminates.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 8 (LED)

        Battery negative (-) → 5 (GND)

        LED illuminates

        If the result is not as specified, replace the rear power window regulator switch assembly (for RH door).