MULTI-DISPLAY REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  5. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

    Click here

  6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

    Click here

  7. REMOVE METER HOOD SUB-ASSEMBLY

    Click here

  8. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  9. REMOVE MULTI-DISPLAY ASSEMBLY WITH BRACKET


    1. B003T3B

      Remove the 2 bolts.

    2. A01MWNH

      Pull the multi-display assembly with bracket as shown in the illustration to disengage the 4 clips.

    3. A01MU97

      Disconnect each connector.

    4. Disengage the clamp and remove the multi-display assembly with bracket.

  10. REMOVE NO. 1 MULTI-DISPLAY BRACKET


    1. A01MUJJ

      Remove the 2 screws and No. 1 multi-display bracket.

  11. REMOVE MULTI-DISPLAY ASSEMBLY