STEERING LINKAGE INSTALLATION

PROCEDURE


  1. INSTALL POWER STEERING LINK ASSEMBLY


    1. Install the power steering link assembly with the 2 bolts, 2 washers and 2 nuts.

      Torque:
      117.6 N*m  { 1199 kgf*cm, 87 ft.*lbf }
    2. B003TG6

      Connect the 2 wire harness clamps to the power steering link assembly.

    3. Connect the 3 wire harness connectors to the power steering link assembly.

      Tech Tips

      When connecting the connector with lock lever, as shown in the illustration, return the lock lever to its original position to connect the connector and securely push in the lock of the lock lever.

  2. CONNECT TIE ROD ASSEMBLY LH


    1. Connect the tie rod assembly LH to the front lower ball joint assembly with the nut.

      Torque:
      65 N*m  { 663 kgf*cm, 48 ft.*lbf }

      Note

      Prevent oil from adhering to the threaded and tapered parts.

    2. Install a new clip.

      Note

      Further tighten the nut up to 60° if the holes for the clip are not aligned.

  3. CONNECT TIE ROD ASSEMBLY RH

    Tech Tips

    Perform the same procedure as for the LH side.

  4. INSTALL STEERING SLIDING WITH SHAFT YOKE SUB-ASSEMBLY


    1. B003V5YC01
      *a Matchmark

      Align the matchmark on the steering sliding with shaft yoke sub-assembly with the matchmark on the power steering link assembly.

    2. B003VDNN01

      Install the bolt (B) and tighten the bolt (A).

      Torque:
      35.3 N*m  { 360 kgf*cm, 26 ft.*lbf }

  5. INSTALL FRONT LOWER SUSPENSION MEMBER PROTECTOR

    for 2GR-FKS: Click here

    for 8AR-FTS: Click here

  6. INSTALL FRONT UPPER NO. 2 SUSPENSION MEMBER

    for 2GR-FKS: Click here

    for 8AR-FTS: Click here

  7. INSTALL SUSPENSION TOWER DAMPER

    Click here

  8. INSTALL NO. 2 ENGINE UNDER COVER

    for 2GR-FKS: Click here

    for 8AR-FTS: Click here

  9. INSTALL FRONT SUSPENSION MEMBER BRACE

    for 2GR-FKS: Click here

    for 8AR-FTS: Click here

  10. INSTALL REAR ENGINE UNDER COVER LH

    for 2GR-FKS: Click here

    for 8AR-FTS: Click here

  11. INSTALL REAR ENGINE UNDER COVER RH

    Tech Tips

    Perform the same procedure as for the LH side.

  12. INSTALL ENGINE UNDER COVER

    for 2GR-FKS: Click here

    for 8AR-FTS: Click here

  13. INSTALL FRONT WHEELS

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  14. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  16. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

    Click here

  17. ROTATION ANGLE SENSOR INITIALIZATION AND TORQUE SENSOR ZERO POINT CALIBRATION

    Click here

  18. VARIABLE GEAR RATIO STEERING SYSTEM CALIBRATION (w/ VGRS)

    Click here