STEERING WHEEL(w/ Pre-collision System) INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the engine switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly with the battery connected and the engine switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

    Click here

  2. INSTALL STEERING SHAKE DAMPER


    1. Install the steering shake damper to the steering wheel sub-assembly with the 2 screws.

      Torque:
      2.4 N*m  { 24 kgf*cm, 21 in.*lbf }

  3. INSTALL STEERING PAD SWITCH ASSEMBLY

    Click here

  4. INSTALL CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)

    Click here

  5. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  6. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here

  7. INSTALL STEERING WHEEL ASSEMBLY


    1. A001I4AC01
      *a Matchmark

      Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.

    2. Install the steering wheel assembly set nut.

      Torque:
      50 N*m  { 510 kgf*cm, 443 in.*lbf }
    3. A001JOK

      Connect the connector.

    4. A001IWR

      Connect the 2 connectors to the spiral cable with sensor sub-assembly.

  8. CHECK STEERING WHEEL CENTER POINT

  9. INSTALL HORN BUTTON ASSEMBLY

    Click here

  10. PERFORM VARIABLE GEAR RATIO STEERING SYSTEM CALIBRATION (w/ VGRS)

    Click here