STEERING WHEEL(w/ Pre-collision System) REMOVAL

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the engine switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly with the battery connected and the engine switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  2. REMOVE HORN BUTTON ASSEMBLY

    Click here

  3. REMOVE STEERING WHEEL ASSEMBLY


    1. A001IWR

      Disconnect 2 connectors from the spiral cable with sensor sub-assembly.

    2. A001JOK

      Disconnect the connector.

    3. A001I4AC01
      *a Matchmark

      Remove the steering wheel assembly set nut.

    4. Put matchmarks on the steering wheel assembly and steering main shaft.

    5. A001JAUC01
      *a Turn
      *b Hold

      Using SST, remove the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05070 )

      Note

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

  4. REMOVE CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)

    Click here

  5. REMOVE STEERING PAD SWITCH ASSEMBLY

    Click here

  6. REMOVE STEERING SHAKE DAMPER


    1. A001HMZ

      Remove the 2 screws and steering shake damper from the steering wheel sub-assembly.

  7. REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

    Click here