STEERING ACTUATOR REMOVAL

PROCEDURE


  1. PRECAUTION

    Click here

  2. REMOVE STEERING COLUMN ASSEMBLY

    Click here

  3. REMOVE FRONT SUSPENSION MEMBER BRACE

    Click here

  4. REMOVE NO. 2 ENGINE UNDER COVER

    Click here

  5. REMOVE LOWER MAIN SHAFT DUST COVER


    1. B003TSD

      Remove the 2 bolts and lower main shaft dust cover.

  6. REMOVE STEERING ACTUATOR ASSEMBLY


    1. B003TM3N04

      Loosen the bolt (A).

      Note

      Do not remove the bolt (A)

    2. Remove the bolt (B).

    3. B003V1JC06
      *a Matchmark

      Slide the steering sliding yoke sub-assembly and put matchmarks on the steering sliding yoke sub-assembly and power steering link assembly.

    4. Separate the steering sliding yoke sub-assembly from the power steering link assembly.

    5. B003SV4

      While pushing the claws on both sides of the connector, move the lock as shown in the illustration.

    6. Disconnect the connector from the steering actuator assembly.

    7. B003VOU

      Using a screwdriver and needle-nose pliers, loosen the clamp as shown in the illustration.

    8. B003UFYC02
      *a Matchmark

      Put matchmarks on the steering actuator assembly and No. 1 steering column hole cover sub-assembly.

    9. Remove the steering actuator assembly with the steering sliding yoke sub-assembly from the vehicle.

  7. REMOVE STEERING SLIDING YOKE SUB-ASSEMBLY


    1. B003V1LC01
      *a Matchmark

      Put matchmarks on the steering sliding yoke sub-assembly and steering actuator assembly.

    2. Remove the bolt and steering sliding yoke sub-assembly.