STEERING ACTUATOR REMOVAL

PROCEDURE


  1. PRECAUTION

    Click here

  2. REMOVE STEERING COLUMN ASSEMBLY

    Click here

  3. REMOVE FRONT SUSPENSION MEMBER BRACE

    Click here

  4. REMOVE NO. 2 ENGINE UNDER COVER

    Click here

  5. REMOVE LOWER MAIN SHAFT DUST COVER


    1. A01MVNI

      Remove the 2 bolts and lower main shaft dust cover.

  6. REMOVE STEERING ACTUATOR ASSEMBLY


    1. B003WG9C01

      Loosen the bolt (A).

      Note

      Do not remove the bolt (A)

    2. Remove the bolt (B).

    3. B003X0EC01
      *a Matchmark

      Slide the steering sliding yoke sub-assembly and put matchmarks on the steering sliding yoke sub-assembly and the power steering link assembly.

    4. Separate the steering sliding yoke sub-assembly from the power steering link assembly.

    5. A01MYDT

      While pushing the claws on both sides of the connector, move the lock as shown in the illustration.

    6. Disconnect the connector from the steering actuator assembly.

    7. A01MZ68

      Using a screwdriver and needle-nose pliers, loosen the clamp as shown in the illustration.

    8. B003X6RC01
      *a Matchmark

      Put matchmarks on the steering actuator assembly and No. 1 steering column hole cover sub-assembly.

    9. Remove the steering actuator assembly with the steering sliding yoke sub-assembly from the vehicle.

  7. REMOVE STEERING SLIDING YOKE SUB-ASSEMBLY


    1. B003V1LC01
      *a Matchmark

      Put matchmarks on the steering sliding yoke sub-assembly and steering actuator assembly.

    2. Remove the bolt and steering sliding yoke sub-assembly.