REAR SUNSHADE ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT REAR WINDOW SHADE ASSEMBLY


    1. Check the operation of the motor.


      1. A0124PHC08
        *a

        Component without harness connected

        (Rear Window Shade Assembly)

        Apply battery voltage and check the operation of the rear window shade assembly.

        OK
        Battery Connection Result

        Battery positive (+) → Terminal 1

        Battery negative (-) → Terminal 2

        		 Rear sunshade raises

        Battery positive (+) → Terminal 2

        Battery negative (-) → Terminal 1

        		 Rear sunshade lowers

        If the result is not as specified, replace the rear window shade assembly.

    2. Check the operation of the limit switch.


      1. A0124LTC03
        *a

        Component without harness connected

        (Rear Window Shade Assembly)
        *b Limit switch off
        *c Limit switch on

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        3 - 4 Limit switch on 10 kΩ or higher
        3 - 4 Limit switch off Below 1 Ω

        If the result is not as specified, replace the rear window shade assembly.