REAR SPEED SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • The speed sensor rotor is a component of the rear axle hub and bearing assembly. If the speed sensor rotor is malfunctioning, replace the rear axle hub and bearing assembly.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  4. REMOVE SPARE WHEEL COVER TRAY (w/o Spare Tire)

    Click here

  5. REMOVE SPARE WHEEL COVER TRAY LH (w/ Spare Tire)

    Click here

  6. REMOVE SPARE WHEEL COVER TRAY RH (w/ Spare Tire)

    Click here

  7. REMOVE DECK SIDE TRIM BOX LH

    Click here

  8. REMOVE DECK SIDE TRIM BOX RH

    Click here

  9. REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER

    Click here

  10. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (for Fixed Seat Type)

    Click here

  11. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (for Fold Down Seat Type)

    Click here

  12. SEPARATE LUGGAGE COMPARTMENT TRIM COVER


    1. B003VYO

      Disengage the 2 claws and open the cover.

    2. B003UNZ

      Remove the bolt and rope hook assembly.

    3. B003UEIN01

      Remove the 4 clips.

    4. for LH Side:


      1. Remove the clip (A).

    5. Separate the luggage compartment trim cover from the body.

  13. REMOVE REAR WHEEL

  14. SEPARATE REAR WHEEL HOUSE LINER


    1. B003UTU

      Remove the 2 nuts and separate the rear wheel house liner.

  15. REMOVE REAR SPEED SENSOR


    1. Turn back the luggage compartment trim cover until the rear speed sensor connector can be seen.

    2. Disengage the rear speed sensor connector.

      B003TSLC01
      *A for LH Side *B for RH Side
    3. B003WJ0

      Remove the 3 bolts and separate the rear speed sensor and 2 sensor clamps from the rear axle carrier sub-assembly and rear upper control arm assembly.

      Note


      • Prevent foreign matter from attaching to the rear speed sensor tip.

      • Clean the speed sensor installation hole and the contact surfaces every time the rear speed sensor is removed.

    4. Turn back the rear wheel house liner until the grommet can be disengaged.

    5. B003WMX

      Remove the 2 nuts and 2 sensor clamps.

    6. Disengage the grommet and remove the rear speed sensor.